wipe off and checkseveral times. NOTE -

sam65166

yilai:

[link widoczny dla zalogowanych]

ith a pencil eraser4. Clean the area again with the alcohol or Simple Green and rinse.5. Shake the touch-up paint for a least a minute to be sure the paint ismixed well.6. Dip the tip of the toothpick into the paint. Don’t get a big blob,just a little paint will do.7. Don’t forget to check for a color match on an inconspicuous area ofthe car like the inside of the hood or trunk8. Touch the tip of the toothpick to the center of the chip. The paintwill run down and begin filling the chip. Let dry for an hour [link widoczny dla zalogowanych], thenblow dry with a hair dryer for a half minute or so.9. Repeat the previous step until the chip is filled just above thesurface.10. When the final application of paint is completely dry, sand the areawith the wet sanding block (dipped in a bucket of water) in onedirection only, no circles [link widoczny dla zalogowanych], until flat. Do not sand too much or youwill sand off the clear-coat [link widoczny dla zalogowanych]! Sand a little, wipe off and checkseveral times. NOTE: Do not do this step unless you are experienced orare willing to spend a few hours sanding, buffing and polishing untilthe surface is restored to its normal shine.11. Run your finger over the chip. If you can feel a bump it still needswork.12. Use your scratch remover or cleaner/wax to bring back the shine (Thisstep may take several applications).

				fora.pl - załóż własne forum dyskusyjne za darmo Powered by phpBB © 2001, 2002 phpBB Group Avalanche style by What Is Real © 2004